Ammunition for 3d youtube firearm 1,2,3
Materials:
- Heavy paper (such as cardstock or construction paper)
- Scissors
- Ruler
- Pen or pencil
- Glue or tape
- Shotshell crimping tool (optional)
Instructions:
1. Cut a rectangular piece of heavy paper that is approximately 4 inches long and 2 inches wide. This will be the body of the shell.
2. Fold the paper in half lengthwise, creasing it firmly. This will create a center line down the length of the paper.
3. Open the paper back up and draw a line across the center line, approximately 1/2 inch from one end of the paper. This will mark where the base of the shotshell will be.
4. Draw a line lengthwise down the center of the paper, starting at the base line and ending about 1/2 inch from the opposite end of the paper.
5. Fold the paper in half again along the center line, pressing firmly to create a sharp crease.
6. Fold the bottom end of the paper up along the base line, creating a bottom flap that is approximately 1/2 inch long.
7. Apply glue or tape to the top edge of the bottom flap, and press the two sides of the paper together to form a tube. Hold the paper in place until the glue or tape dries.
8. Fill the tube with the desired amount of shot.
9. Cut a circular piece of paper that is slightly larger in diameter than the open end of the tube. This will be the top wad.
10. Place the top wad over the open end of the tube, and press it down firmly to create a seal.
Materials:
- Heavy paper (such as cardstock or construction paper)
- Scissors
- Ruler
- Pen or pencil
- Glue or tape
- Shotshell crimping tool (optional)
Instructions:
1. Cut a rectangular piece of heavy paper that is approximately 4 inches long and 2 inches wide. This will be the body of the shell.
2. Fold the paper in half lengthwise, creasing it firmly. This will create a center line down the length of the paper.
3. Open the paper back up and draw a line across the center line, approximately 1/2 inch from one end of the paper. This will mark where the base of the shotshell will be.
4. Draw a line lengthwise down the center of the paper, starting at the base line and ending about 1/2 inch from the opposite end of the paper.
5. Fold the paper in half again along the center line, pressing firmly to create a sharp crease.
6. Fold the bottom end of the paper up along the base line, creating a bottom flap that is approximately 1/2 inch long.
7. Apply glue or tape to the top edge of the bottom flap, and press the two sides of the paper together to form a tube. Hold the paper in place until the glue or tape dries.
8. Fill the tube with the desired amount of shot.
9. Cut a circular piece of paper that is slightly larger in diameter than the open end of the tube. This will be the top wad.
10. Place the top wad over the open end of the tube, and press it down firmly to create a seal.
by Cody5050 May 22, 2023
Ammunition for 3d youtube firearm 1,2,3
Gunpowder, also known as black powder, is a mixture of three main ingredients: potassium nitrate (also known as saltpeter), charcoal, and sulfur. The ingredients are mixed together in specific proportions and then ground into a fine powder.
The traditional formula for gunpowder is 75% saltpeter, 15% charcoal, and 10% sulfur by weight. However, the proportions can vary depending on the desired properties of the powder.
To mix the ingredients, they are typically pulverized separately and then combined in a mixing bowl or mortar and pestle. The mixture is then ground and blended thoroughly until it forms a homogenous powder.
It is important to note that creating gunpowder can be dangerous and requires specialized knowledge, equipment, and permits. It is not recommended for individuals without proper training and experience to attempt to make their own gunpowder.
Gunpowder, also known as black powder, is a mixture of three main ingredients: potassium nitrate (also known as saltpeter), charcoal, and sulfur. The ingredients are mixed together in specific proportions and then ground into a fine powder.
The traditional formula for gunpowder is 75% saltpeter, 15% charcoal, and 10% sulfur by weight. However, the proportions can vary depending on the desired properties of the powder.
To mix the ingredients, they are typically pulverized separately and then combined in a mixing bowl or mortar and pestle. The mixture is then ground and blended thoroughly until it forms a homogenous powder.
It is important to note that creating gunpowder can be dangerous and requires specialized knowledge, equipment, and permits. It is not recommended for individuals without proper training and experience to attempt to make their own gunpowder.
by Cody5050 May 22, 2023
by pintoloco October 01, 2020
Catch-all term for all of the nonsensical bullshit spewed by business consultants and middle managers.
Speaker: As you can see from this diagram, an exponential ROI can be realized from our rapid adoption of this strategy.
Me: Fuck me. More 3D Colored Cubes from the boneheads downtown.
Me: Fuck me. More 3D Colored Cubes from the boneheads downtown.
by geekmalone August 19, 2020
3d egg bald vomit is gyoulifp
by ACK shmo March 01, 2022
A nintendo CLASSIC from the early 2010s, succeeding the DSi and all DS's, if you don't know, The Nintendo 3DS is a handheld game console developed by Nintendo, released in 2011. It succeeded the Nintendo DS and introduced several new features, including glasses-free 3D effects, motion controls, and a Circle Pad for improved control. The 3DS is part of the eighth generation of gaming consoles and was a direct competitor to Sony's PlayStation Vita.
The 3DS family includes several models, such as the original 3DS, the larger 3DS XL, and the more affordable 2DS, which lacks the 3D feature. The system is backward compatible with Nintendo DS games and has a vast library of titles, including popular franchises like Mario, Zelda, and Pokémon.
Despite its discontinuation in 2020, the 3DS remains a beloved console for its innovative features and extensive game library. it has a knockoff named The BFDI DDS, or Battle for Dream Island DoDecaScreen, is a fictional handheld game console featured in the animated web series "Battle for Dream Island" (BFDI). It was introduced as a prize for the final 12 contestants in the episode "A Leg Up in the Race." The name "DDS" stands for "dodeca-screen," reflecting its unique design with 12 screens. The console is foldable and includes a D-pad, a circle pad, and multiple buttons.
The 3DS family includes several models, such as the original 3DS, the larger 3DS XL, and the more affordable 2DS, which lacks the 3D feature. The system is backward compatible with Nintendo DS games and has a vast library of titles, including popular franchises like Mario, Zelda, and Pokémon.
Despite its discontinuation in 2020, the 3DS remains a beloved console for its innovative features and extensive game library. it has a knockoff named The BFDI DDS, or Battle for Dream Island DoDecaScreen, is a fictional handheld game console featured in the animated web series "Battle for Dream Island" (BFDI). It was introduced as a prize for the final 12 contestants in the episode "A Leg Up in the Race." The name "DDS" stands for "dodeca-screen," reflecting its unique design with 12 screens. The console is foldable and includes a D-pad, a circle pad, and multiple buttons.
by septuagint bambi July 13, 2024