3d gunner youtube
Gorilla glue and sawdust can be used to create a molded part that is strong and durable. Here is how you can make a molded part using Gorilla glue and sawdust:
Materials:
- Gorilla Glue
- Sawdust
- Mixing bowl
- Measuring cup
- Mixing spoon or spatula
- Mold or form
- Sandpaper
Instructions:
1. Mix the Gorilla Glue and sawdust together in a mixing bowl. Start with a ratio of 1:1, and adjust as needed to achieve the desired consistency. The mixture should be thick and moldable, but not too dry or too wet.
2. Press the mixture into the mold or form, making sure to pack it tightly and evenly. Smooth out the surface as much as possible.
3. Let the mixture dry for at least 24 hours, or until it is completely hardened.
4. Remove the molded part from the mold or form. If necessary, use a knife or other tool to carefully pry it loose.
5. Sand the surface of the molded part with sandpaper to remove any rough or uneven spots. You can also use sandpaper to shape and refine the part as needed.
6. Your molded part is now ready to use! It can be painted or finished as desired.
even substitue the sawdust for your drywall if ground with morter and pestol glue sticks work if mixed with alcohol.
Gorilla glue and sawdust can be used to create a molded part that is strong and durable. Here is how you can make a molded part using Gorilla glue and sawdust:
Materials:
- Gorilla Glue
- Sawdust
- Mixing bowl
- Measuring cup
- Mixing spoon or spatula
- Mold or form
- Sandpaper
Instructions:
1. Mix the Gorilla Glue and sawdust together in a mixing bowl. Start with a ratio of 1:1, and adjust as needed to achieve the desired consistency. The mixture should be thick and moldable, but not too dry or too wet.
2. Press the mixture into the mold or form, making sure to pack it tightly and evenly. Smooth out the surface as much as possible.
3. Let the mixture dry for at least 24 hours, or until it is completely hardened.
4. Remove the molded part from the mold or form. If necessary, use a knife or other tool to carefully pry it loose.
5. Sand the surface of the molded part with sandpaper to remove any rough or uneven spots. You can also use sandpaper to shape and refine the part as needed.
6. Your molded part is now ready to use! It can be painted or finished as desired.
even substitue the sawdust for your drywall if ground with morter and pestol glue sticks work if mixed with alcohol.
Part 3
3d youtube firearm 3
3d youtube firearm 3
by Cody5050 May 22, 2023